This bracket will fit any car that has a space at least 3.5 inches wide and 1.5 inches deep of flat painted surface on the bumper cover to attach the mounting base to. Should be mounted on the center of the bumper cover. (see images for example)
* Made in the USA from non-corrosive metal (aluminum and stainless steel)
* Light weight
* Quickly and easily removable for car shows and cleaning
* Places the license plate on the center of the bumper where it was intended to be mounted.
* The 3M tape will not leave any sticky residue if/when you decide to completely remove it.
*CAUTION: Not recommended for install over vinyl stripes or clear bra/PPF type material.
The bracket that holds the license plate is laser cut from 16ga plate stainless steel (NOT PLASTIC) weighing in at only 7 oz. with the license plate attached. It has rubber bumper protection in place, to prevent vibration and so no metal part of the bracket never touches the painted portion of the car.
The mounting base is 6061 Billet machined Aluminum. It comes with a custom knurled thumb nut used to fasten the license plate bracket to the mounting base. The mounting base is attached to the bumper cover, out of sight, using 3M 4910 adhesive tape, some of 3M's strongest hold tape on the market.
The all new attachment design was tested at various stages. It was initially tested by mounting the base to a painted surface with the bracket attached and we let it sit for a week; it didn't move. Then we hung 10lbs of weight off the mount with the bracket attached and let it sit for a week; it didn't move. Then we mounted it on a 2015 Mustang GT, took it up to 100mph using the 3M tape mounting option; it didn't move. The mount is tested and proven and under no circumstances requires any additional screws to hold it in place. Trust me, I had to pull a mounting base off JLT's car to mount the final version and it was stuck on tighter than @#$%^&!
This bracket is very low profile and can hardly be seen when mounted. It places the license plate exactly where it is intended to be placed, not under the front splitter where it gets ripped off by curbs, steep driveways or when you forget to put it up before driving. The mounting base can be installed in minutes and the license plate bracket installed and removed in seconds using our quick release thumb nuts. If you want a more permanent attachment, you can use a 1/4 x 20 nylon locking type nut and washer.